What does the daily maintenance of fountain equipment need to do?

Everyone knows that fountain equipment is mainly composed of fountain water quality, sprinkler, water pump, underwater lantern and other components, each component has its own unique characteristics and role, no matter which component failure will affect the normal work of fountain equipment. What does the daily maintenance of fountain equipment need to do?

1. water quality of fountain equipment

The water quality of the fountain equipment shall not exceed 15 degrees of chromaticity, and shall not present other heterochromatic colors, and the turbidity shall not exceed 10 degrees; and shall not contain naked eye visible substances. The content of impurities in water is not more than 0.1%, the particle size of impurities is not more than 0.2 mm, the content of chloride ion is not more than 400 mm/L, and the PH value is in the range of 6.5-8.5. At the same time, attention should be paid to the recycling of water for fountain equipment. When the nozzle is required, the recycling water should be filtered. The amount of supplementary water in the circulating system should be determined according to the loss of evaporation, air blowing, leakage and sewage discharge. Generally, 5%-10% of the circulating flow rate should be used.

2. sprinkler

The sprinkler head should be cleaned and maintained regularly, and the tightness of the connection between the sprinkler head and the pipeline should be paid attention to when installing the sprinkler head. A layer of raw material belt should be wrapped around the filament of the pipeline when the sprinkler head is put on, so as to avoid water leakage and influence the sprinkler effect. At the same time, the anti-theft measures

3. underwater lantern

Underwater color lanterns are very vulnerable components of fountain equipment, so the daily maintenance of color lanterns is also extremely important. The best use of heat shrinkable tube and thermal sol waterproof; in the assembly of color lamp to ensure that the connection between the lamp and lamp holder is tight, not loose; pipeline welding lamp, lamp must be tightly welded to prevent the use of lamp shedding; after assembly, it should be immersed in 5% salt water 72 hours, measured resistance can be used after qualified.

4. pump

Problems often occur in water pumps, such as no water outlet, indirect water outlet or less water outlet, motor can not start and accompanied by buzzing, motor winding resistance to the ground insulation resistance is low and so on. The main causes of these phenomena are blockage of motor not starting pipeline, pipeline rupture, filter network blockage, suction outlet water surface, pump reversal, impeller. There are foreign bodies, at this time we must first find out the cause of the fault, clean up the fault or blockage, repair lines or replace bearings, etc., so that the pump can work properly.

The last page：[rationale surfing the Internet to welcome nineteen big cities] uphold the concept of ecological civilization, and vigorously promote green development.
the next page：What is the design and manufacturing principle of music fountain?